IAmOutaSight Posted April 3, 2012 Share Posted April 3, 2012 Haveing some issues with the hub not working like it did before. use to be able to see bans and have a welcome sent and it stopped doing it. I have re set up the hub and still nothing.. Any ideas? Quote Link to comment Share on other sites More sharing options...
fozzer Posted April 3, 2012 Share Posted April 3, 2012 The server attached to your team account is currently streaming (216.157.84.129:25200) and has the relevant flags checked to "announce bans". You have no saved greetings for your server. I can see that you yourself edited the server greeting on April 03 2012: Edited Server Greeting |216.157.84.129:25200| Welcome $CURRENT_NICK. We stream to PBBANS but it was not saved. In case this is relevant; All none streaming issues are client side. The first thing to do when a server just stops streaming is to run the Automated Hub Setup again; http://www.pbbans.com/automated-streaming-setup.html If you are having to go through the setup procedure every time the server restarts, it's obvious that your server is on a "crontab" of sorts and the server is loading a default cfg that does not contain your streaming commands that you sent to it in the setup phase, or your streaming settings are being held in a cfg that is not loaded by default after a server restart. If you can not figure it out yourself, raise a ticket with your RSP and tell them what your issue is .. hopefully they can then sort it out for you :) The correct file system within your PB directory should be; pbsv.cfg - contains all your PB server settings (including your pbucon settings) pbsvuser.cfg - contains all the scans (MD5 etc) that a server admin wishes to run on his server. pbucon.use - is a file that is only needed to run pbucon and is best left blank. Forcing anything other than what's listed above is asking for trouble and judging by the amount of tickets and questions we see, certain RSP's are certainly getting it. Points to note for all the RSP "experts" who think putting PB server settings in a pbucon.use file is a good idea. pbsv.cfg is loaded by default after a server restart. pbsvuser.cfg is loaded by default after a server restart. pbucon.use is not loaded by default after a server restart .. PB only checks if this file is present or not and then does nothing. Quote Link to comment Share on other sites More sharing options...
Crazzie_Canuck Posted April 3, 2012 Share Posted April 3, 2012 Also http://www.pbbans.com/forums/pbguid-is-now-ea-guid-minus-ea-prefix-t158853.html Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.