Jump to content

Single server stopped streaming


Magician

Recommended Posts

85.236.100.7:19867

BF3

 

This server was streaming before up until a little over a week ago and I checked that the config is all set up and PB is running but the hub doesn't see it anymore for some reason. Can staff please check this? Thanks.

Link to comment
Share on other sites

I tried readding the server because I could not get a response on IRC after a few days of trying. Before it last streamed on Dec 1, using the same config it has now.

Edited by Magician
Link to comment
Share on other sites

All none streaming issues are client side.

 

The first thing to do when a server just stops streaming is to run the Automated Hub Setup again;

http://www.pbbans.com/automated-streaming-setup.html

 

If you are having to go through the setup procedure every time the server restarts, it's obvious that your server is on a "crontab" of sorts and the server is loading a default cfg that does not contain your streaming commands that you sent to it in the setup phase, or your streaming settings are being held in a file that is not loaded by default after a server restart.

If you can not figure it out yourself, raise a ticket with your RSP and tell them what your issue is .. hopefully they can then sort it out for you :)

 

The correct file system within your PB directory should be;

 

pbsv.cfg - contains all your PB server settings (including your pbucon settings)

 

pbsvuser.cfg - contains all the scans (MD5 etc) that a server admin wishes to run on his server.

 

pbucon.use - is a file that is only needed to run pbucon and is best left blank.

 

Forcing anything other than what's listed above is asking for trouble and judging by the amount of tickets and questions we see, certain RSP's are certainly getting it.

 

Points to note for all the RSP "experts" who think putting PB server settings in a pbucon.use file is a good idea.

 

pbsv.cfg is loaded by default after a server restart.

 

pbsvuser.cfg is loaded by default after a server restart.

 

pbucon.use is not loaded by default after a server restart .. PB only checks if this file is present or not and then does nothing.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.