Couple of server questions

[=DDC=Frost]

I have recently added a second server however for some reason I am having problems getting screenshots to show up publicly accessable for what ever reason. I never had this issue with my first server at gameservers, but this one is through seemeplayme. Do you guys have any ideas or suggestions? Thanks. Plus I also noticed that this server is yet to be listed as streaming on pbbans. I have the streaming info setup exactly the same as it is for this server as my first one. The servers ip in question is 209.160.39.52:1716

Once again thanks for any help on either of these problems.

[fozzer]

PBBans Hub Server Results
Server Status 	Server is not streaming via Hub
Server Info
Clan Tag 	=DDC=
Server IP 	209.160.39.52:1716
Data Last Received 	Unknown
Hub Options
General 	Accept Hub Bans
Log Forwarding 	ACI CB AON

http://www.pbbans.com/forums/index.php?showtopic=29047

 

Re screenshots;

Does the command pb_sv_AutoSs 1 exist in your pbsv.cfg ?

http://www.pbbans.com/forums/index.php?aut...amp;showfile=16 .

[Benway]

in case there are other ucon sessions opened (AON-AdminPanel, check: pb_sv_UconList) try to increase pb_sv_USessionLimit value, see http://www.pbbans.com/forums/index.php?showtopic=29047 (updated)

[=DDC=Frost]

I went ahead and followed the instructions under that link provided and hopefully it will begin streaming now. However I did not find the ss link to be any further help. Here is my copy of my ss settings cfg and also note that ss's are being saved into my ftp folder however I cannot access them via htm

 

;**************Punkbuster Screenshot settings**************

pb_sv_SsFloor 1 //[Low screenshot filename serial #]

pb_sv_SsCeiling 2000 //[High screenshot filename serial #]

pb_sv_SsCmd "" //[Filename of system command to run after screenshots]

pb_sv_SsWidth 1280 //[Requested pixel width of remote screenshots]

pb_sv_SsHeight 1024 //[Requested pixel height of remote screenshots]

pb_sv_SsXpct 47 //[Percentage across screen for remote screenshots]

pb_sv_SsYpct 47 //[Percentage down screen for remote screenshots]

pb_sv_SsSrate 2 //[sample Rate for remote screenshots]

pb_sv_SsDelay 20 //[Maximum delay client waits before capturing screenshot]

pb_sv_SsPath "" //[Path where remote screenshots are saved]

pb_sv_AutoSsFrom 60 //[Min # of seconds to wait before requesting next ss]

pb_sv_AutoSsTo 600 //[Max # of seconds to wait before requesting next ss]

pb_sv_AutoSs 1 //[0=No, 1=Yes (default=0)]

pb_sv_ssLogging 0 //[1=Reg. Log, 2=SS Log, 3=Both, 0=Neither]

pb_sv_ssTimeout 0 //[seconds]

[siskin]

I think this is a smpm issue frost.. Have you contacted them to find out where you can view the shots?

 

My provider here in Australia uses a different URL than the norm to host the SS's - perhaps they do too.

 

I am not familiar with them as providers myself, but I have read some posts here and there that lead me to believe they handle things slightly differently than gameservers.

 

Otherwise your SS settings look fine to me.

 

Good luck

[=DDC=Frost]

Ok thanks for the help. I will look into this on their end and hope to make some headway there. :) Hooah

[siskin]

I just rechecked my own settings and discovered that I have neither of the last two entries in my own server.. those that refer to logging.

 

Maybe try changing the "pb_sv_ssLogging 0 //[1=Reg. Log, 2=SS Log, 3=Both, 0=Neither]" to 2 or 1 and then the

"pb_sv_ssTimeout 0 //[seconds]" to say 45 or 60..

As it is players are either getting an indeterminate time to timeout or no time at all.

 

I hope that helps some.. but I would still contact smpm and ask them to sort out the SS viewing for you.

[fozzer]

I went ahead and followed the instructions under that link provided and hopefully it will begin streaming now.

PBBans Hub Server Results
Server Status 	Server is streaming via Hub
Server Info
Clan Tag 	=DDC=
Server IP 	209.160.39.52:1716

Streaming sorted, :) best of luck with your screenshot issue.

[RoadWarrior]

I've had some issues recently with gameservers not setting the proper read/write permissions to certain folders. Sometimes you can change them yourself by clicking on the appropriate file-folder and selecting the option, other times you have to put in a ticket. Along with that, if they have not set you up with permissions to view, the files could be there, but you may not be able to access them.

 

I've had to send in a ticket or two regarding this, and they've always gotten me fixed up. My advice, if the above fixes have not worked regarding viewing your ss's, send them a ticket with as much detail as you can. It can be a very simple fix on their end if they know what they're to look for.